Telnet Console; Figure 48 Telnet Console - Acer ARMC_3P User Manual

52
vated (if the serial settings were made accordingly). All inputs are redirected to the
device on serial port #1 and its answers are displayed on the Telnet interface.
The following list shows the command syntax and their usage.
help
Displays the list of possible commands
quit
Exits the current session and disconnects from the client
version
Displays the release information
terminal
Starts the terminal pass-through mode for serial port #1. The key sequence
esc exit switches back to the command mode. The command has an optional
parameter (1 or 2) to select the desired serial port for pass-through access.
reset [host|card]
Resets the given target, the host system or the ARMC/3P card. If no reset
target is given it defaults to "host". Note that resetting the ARMC/3P results in
disconnecting every client. This includes also the client the reset command
was sent from.
power [on|off [short|long]]
The host is powered on or off. If no new power state is given, the current

Figure 48 Telnet Console

P U G
RODUCT SER UIDE