Figure 86 Date And Time; Authentication - Acer ARMC_3P User Manual

C 5: M O
HAPTER ENU PTIONS
this access type is a host system with IPMI V1.5 and a network adapter with
a sideband connection to the BMC (mostly on board). In the IPMI Settings
you have to enter the IP address of this host system, the user name of a valid
IPMI account and password for this account. You can also access other IPMI
systems if you enter their IP address.
This link refers to a page where the internal realtime clock of the ARMC/3P can be
set up (see Figure 86). You have the possibility to adjust the clock manually or to
use a NTP time server. Without a time server your time setting will not be
persistent, so you have to adjust it again after the ARMC/3P loses power for more
than a few minutes. To avoid this you can use a NTP time server which sets up the
internal clock automatically to the current UTC time. Because NTP server time is
always UTC, there is a setting that allows you to set up a static offset to get your
local time.
With the ARMC/3P you have the possibility to use either a local authentication or
keep the information in a central LDAP directory or in a RADIUS server. For LDAP
or RADIUS you have to specify some information in the Authentication settings
panel. For more information regarding the LDAP and RADIUS settings see below.
LDAP
User LDAP Server
Here you enter the name or IP address of the LDAP server containing all the

Figure 86 Date and Time

93