RH Baby&child BELLINA STORAGE CONVERSION CRIB Assembly Instructions Manual page 7

STEP 2
MATTRESS SUPPORT ASSEMBLY
STEP 2.1
Attach the support arms to the mattress support using Allen bolts
(CC), lock washers and plain washers. See DETAIL D.
STEP 2.2
Hang the mattress support on both side panels by using Allen
bolts (CC), lock washers and plain washers to attach the support
arms into the fixed nuts in the side vertical rails of the side panels.
See DETAIL E.
WARNING:
Set the mattress support to the desired height by adjusting the
support arms. The mattress support should be at its highest
setting for newborns, then adjusted to the lower positions as the
child grows and becomes mobile. Once the child is able to stand,
the mattress support should be at its lowest position.
HARDWARE NEEDED FOR STEP 2:
(CC) 1/4" x 13/16 " Allen Bolt = 8 pcs.
Lock Washer 1/4" = 8 pcs.
Plain Washer 1/4" = 8 pcs.
Support Arm
DETAIL E
(BB)
Allen Wrench = 1 pc.
DETAIL D
(CC)
D
E
Support Arm = 4 pcs.
7/11