Installation; Removal; Battery Charging & Maintenance - Snorkel SL26RTE Parts & Service Manual

SERVICE AND REPAIR
CHOCKING THE ELEVATING ASSEMBLY

INSTALLATION

1. Park the work platform on a firm, level ground
and leave the engine running.
2. Elevate the platform approximately 300 mm (12
inches).
3. Place a jackstand with a minimum rating of
2000 kg (400 lbs.) between the lower mast and
chassis, just behind the front axle.
4. Gradually lower the platform until the jackstand
is secured tightly between the lower mast and
chassis.

REMOVAL

Elevate the platform until the jackstand can be removed. Remove the jackstand and completely
lower the platform.
BATTERY CHARGING AND MAINTENANCE
Ensure the machine batteries are recharged at the end of the working shift, do not store machine
for long periods of time with partially charged batteries. Permanent damage to the batteries will
result if the batteries are not immediately re-charged after dis-charging.
Use the following procedure to charge the batteries.
1. The battery disconnect switch is at the rear of the control cabinet (Refer to Fig 3.1.1), ensure
the switch is set to ON before charging.
2. Plug the charger into a properly grounded AC outlet using a 3 conductor, 12 guage (2.5mm
core) or larger extension cord. The extension cord must be as short as possible and in good
electrical condition.
3. Leave the charger plugged in permanently or until last green light on the battery charge indica-
tor illuminates (Refer tp Figure 3.1.2).
4. If the machine is intended to be stored for large periods of time ensure the batteries are fully
charged before storing. After periods of 3 months batteries must be re-charged fully to preserve
battery life.
Page 3 - 4
! C A U T I O N
DO NOT support or raise the front of the platform during any
maintenance operation as this may result in damage to the tension
members.
W A R N I N G
!
Before performing maintenance on a work platform while it is elevated,
ensure that the elevating assembly is properly supported.
DO NOT stand under the elevated assembly area while installing or remov-
ing the jackstand.
!
!
Figure 3-1: Blocking the elevating assembly
SL26/30SL