Snorkel SL26RTE Parts & Service Manual page 95

SERVICE AND REPAIR
LEVELLING PROCEDURE
1. Place the machine on a firm, level surface. Using a digital inclinometer, check that the chas-
sis and the front axle are level with each other within +/- 0.25 degrees side to side.
2. Using the manual levelling procedure (refer to page 3-15), level the platform using a digital
inclinometer to within +/- 0.25 degrees.
NOTE: Since level has not yet been calibrated, ignore the level indicators on the platform
and level using the digital inclinometer only.
3. Switch the machine to ground controls.
4. Press and hold "ESC" for 5 seconds until "#### MENU: HELP: PRESS ENTER" is dis-
played.
5. Scroll to "ACCESS LEVEL" and press "ENTER".
6. Enter the code 2222 for "ACCESS LEVEL 2" and press "ENTER".
7. Scroll to "SETUPS" and press "ENTER".
8. Scroll to "TILT SETUPS" and press "ENTER".
9. The question "CALIBRATE LEVEL" pops up. Press "ENTER".
10. Press "ENTER" for yes.
To confirm level calibration has worked, switch the machine off then back on again.
11. Press and hold "ESC" for 5 seconds.
12. Scroll to "DIAGNOSTICS" and press "ENTER".
13. Select "SYSTEM" and press "ENTER".
14. Scroll to "TILT" to display the platform tilt angles.
15. Press "ENTER" to display the chassis tilt angles.
16. Press "ESC" then scroll to "AXLE" and press "ENTER" to display the axle tilt angles.
17. All angles displayed during 14, 15 and 16 should be below 0.2 degrees. If not, repeat the
procedure from 5.
Page 3 - 18
Esc to leave
Sub-Menu
without saving.
ESC
Scroll
Left/Right
Figure 3-12: EZcal Display
Display
Change Entry
Up / Down
Enter to Save
ENTER
Entry
SL26/30SL