Function Of External Inputs E1 And E2; Software Reset - RADEMACHER Troll Basic DuoFern 5615 Instruction Manual

i

24. Function of external inputs E1 and E2

The Troll Basic DuoFern features two external inputs E1 (up) and E2 (down) for connecting
an external switch. If all automatic functions are deactivated, the inputs will not be taken into
consideration by the system.
Function in normal mode
The mode of operation and order of switching corresponds to manual mode, as described
on page 19.
Press the up key (E1).
1.
Press the down key (E2).
2.
Function in jog mode:
◆ Jog mode is active only if the Venetian blinds function has been previously activated in
the DuoFern controller (e.g. HomePilot®).
◆ The mode of operation and order of switching corresponds to manual jog mode, as
described on page 20.
i
25. Software reset (restore factory settings)
If necessary, you can erase all of your settings and return the Troll Basic DuoFern system to its
original factory settings.
+
1.
All of the LEDs flash red by way of confirmation.
2.
Release the buttons...
3.
All settings will be erased and reset to the default factory settings.
NOTE
If the Troll Basic DuoFern fails to react to the software reset, then we recommend briefly
disconnecting the device from the mains.
The roller shutters travel up.
The roller shutters travel down.
+ + Simultaneously press and hold all four buttons for
4 seconds.
EN
37