JAI SW-4000Q-SFP User Manual page 61

White balance
Test pattern
Image porcessing
PRNU
DSNU
Power supply voltage
Connectors / LEDs
Lens mount
Flange back
Operating temperature / humidity
Storage temperature / humidity
Vibration resistance
Impact resistance
Standard compliance
Dimensions
Weight
Package contentsCamera
body (1)
Sensor protection cap (1)
Dear Customer (sheet) (1)
Design and specifications are subject to change without notice.
Approximately 30 minutes of warm-up are required to achieve these specifications.
Caution
About the verified performance temperature
Make sure the following temperature condition is met when operating the unit.
1) The camera's internal temperature sensor detects temperatures of 65 °C or less during
operation.
If the above temperature conditions are exceeded, take measures to dissipate heat according to
your installation environment and conditions.
BalanceWhiteAuto
Adjustment range
Available : Off、White、GrayPattern1(Ramp)、GrayPattern2(Stripe)、ColorBar
1 Pixel sensitivity correction: Pixel correction (DSNU, PRNU)
2 Shading correction: ColorShading, FlatShading
3 LUT: OFF: γ＝1.0, ON: 257 points can be set
4 Gamma: 0.45, 0.5, 0.55, 0.6, 0.65, 0.75, 0.8, 0.9, 1.0 (9 steps available)
Post-correction: Within ±1% (during 100% output)
Post-correction: Within ±5% (during 0% output)
12pin
SFP+
12pin (DC IN/TRIG)
10pin (AUX)
LED (Power/TRIG)
M52 mount, F mount
*) Maximum allowed rear protrusion on lenses: 13mm
M52 mount: 46.5 mm (in air), tolerance: 0 mm to –0.05 mm
F mount: 46.5 mm, tolerance: 0 mm to –0.05 mm
­ 5℃〜＋ 45℃ / 20％〜 80％
（non-condensing）
­ 25℃〜＋ 60℃ / 20％〜 80％
（non-condensing）
3G（20 Hz 〜 200 Hz X-Y-Z direction）
50G
CE(EN61000-6-2 and EN61000-6-3), FCC part 15 class B, RoHS, WEEE, KC
90 × 90 × 120 mm (WHD; excluding mount and protrusions)
980 g (typ.)
— 61 —
Off, Once, Exposure Once, Preset5000K, Preset6500K, Preset7500K
4000K 〜 9000K
Input range︓ DC ＋10V 〜＋ 25V
consumption︓ 17.4 W(typ.)
(at 12 V input, full pixel, Default setting, Environmental
temperature 25°C) (Typical)
24.8 W
(Maximum)
10GBASE-R
Power level 1
Model ︓ HR10A-10R-12PB(71) (or equivalent)
Function︓ Power supply input / External trigger / External I/O
Model
Camera side︓Equivalaent to Hirose Electronic 3260-10S3 (55)
Cable side ︓Equivalaent to Hirose Electronic 350-10P-C (50)
Function︓ External tigger / External I/O
Function︓Power on, trigger input indicator
SW-4000Q-SFP