Front-/Rear Axle / Lift Cylinder; Rear Axle; Removing The Rear Axle; Reattaching The Rear Axle - Husqvarna FS 5000D Workshop Manual

14.7
1
3A
4
1
74
FRONT- / REAR AXLE / LIFT CYLINDER
2
3B
5
Heavy
2
14.7. FRONT-/
REAR AXLE / LIFT
CYLINDER

Rear Axle

First see Lifting the Road Saw (p.
72).

Removing the Rear Axle

1� Remove the two weels with 4
screws each� (Must not be done,
but the axle will be lighter�)
2� Cover ground with a carpet to
reduce oil spill and unplug two
hydraulic connectors and plug the
hoses�
3� A (e-track): Remove the first cotter
pin to the e-track and push e-track
to the side�
B (manual e-track): Unscrew the
two nuts and Remove the long
screw�
4� Remove the pin at the castle nut�
5� Use a jack or get help lifting�
Warning! The rear Axle is heavy�
Remove castle nut and washer (37
mm socket) and slowly lower the
rear axle to the ground�

Reattaching the Rear Axle

1� Apply grease on the nut� Mount
the axle with washer and castle nut
then put a new pin thrue the bolt�
2� Put the e-track back and insert at
new cotter pin, or follow 3B above
in reverse if you have the manual
version�