Function Test - Husqvarna FS 5000D Workshop Manual

8. FUNCTION TEST

Function Test
Follow these steps to make sure that every function of the flat saw works properly before service and maintenance is
carried out�
• Start the Engine�
• Turn the throttle knob and verify that the engine rev up�
• Slowly pull the Speed Control forward� The saw should gently start to go forward�
• Slowly pull the Speed Control backward� The saw should gently start to go backwards�
• Put the Speed Control in (P)
• For saws equipped with a clutch� Engage the clutch� Verify that the blade starts turning, and make sure that the
blade stops turning when the clutch is disengaged�
• Turn off the engine�
• For saws equipped with E-track� Make sure that the E-Track function moves according to the Operators manual�
• Raise the saw to its maximum height� Verify that it sets in that position�
• Turn the lowering speed valve knob clockwise to its closed position� Try to lower the saw� The saw should not
start to lower with the valve in this position�
• Turn the lowering speed valve knob counterclockwise 1/8 of a turn� And try to lower the saw� The saw should
now slowly lower itself�
• Make sure that the Blade depth stop works according to the Operator's Manual and stops at the set value�
FUNCTION TEST 8
15