Gear Box; Removing The Gear Box - Husqvarna FS 5000D Workshop Manual

1
3
5
7
9
GEARBOX / CLUTCH / BLADE SHAFT
2
4
6
8
10

Gear Box

First see Removing the Blade
Shaft Drive Belts (p. 64).

Removing the Gear Box

1� Disconnect the water hoses and
drain fittings from the gearbox.
2� Slip a short 2x4 under the bell
housing of the engine�
3� Remove the two horizontal bolts
located just behind the two
jacking bolts�
4� Back out the jacking bolts to lower
the engine down onto the 2x4�
5� Disconnect the clutch wire from
the wiring harness (if there is a
clutch)�
6� Remove the gear selector�
7� Unscrew the nob and slide the
gear selector out�
8� Secure the gear box with a
overhead crane�
9� Remove the two protetection
covers with two screws with
washers on each side, these screws
also fasten the gearbox to the
engine�
10� Remove the two screws with
washers at the bottom that fasten
the gear box to the engine�
14.5
67