Table of Contents
Advertisement
15
17
19
ELECTRICS / HYDRAULICS
16
18
20
15� Unplug the depth sensor contact
located behind the battery�
16� Unplug the Proximity Sensor�
17� Disconnect the clutch wire (if the
saw is equipped with clutch) from
the wiring harness located behind
the gear box bracket�
18� Disconnect the wire from the fuel
pump�
19� On the right side� A: Disconnect
the generator cable� B: Remove the
signal cable to the starter motor,
one screw� Also remove the feed
cable to the start engine with one
nut� And the cable that connects
the start engine to the generator�
20� Disconnect the cable X15 from
the coil� Remove the cable X107
from the solenoid�
Remove ground cable from the
engine with one screw (only
necessary when lifting the engine)�
14.2
51
Hide quick links:
Advertisement
Table of Contents
