Mounting The Gearbox - Husqvarna FS 5000D Workshop Manual

14.5
11
13
1
3
68
GEARBOX / CLUTCH / BLADE SHAFT
12
2
4
11� Remove the two nuts at the upper
part of the gearbox at the same
time as you use a screwdriver to
disconnect the gearbox and slide it
away from the engine�
12� Use the overhead crane to lift the
gearbox off� Place the front side
down on your work surface�
13� Remove the pulleys and bracket�

Mounting the Gearbox

1� Use the overhead crane to lift the
gearbox in place�
2� Fit it on to the two screws and
fasten the nuts with washers�
3� Insert the remaining screws and
fasten them�
4� Mount the two covers with two
screws each�