Table of Contents
Advertisement
15
Downloading HMI software
The first time MfgTool is used on a computer new drivers will be
automatically installed. This may cause the above described process for
entering programming mode to be interrupted. If this happens repeat
the process.
HMI software is supplied by Husqvarna at http://support.husqvarnacp.com/ as a zip file that contains both the
HMI software and MfgTool. Start MfgTool by executing file MfgTool.exe. The MfgTool looks like the image below.
In section A you can now see the text HID-compliant device� If it does not appear, 1) Try to click on the Scan devices
button� 2) Check the USB connection� 3) Try another USB port� 4) If you have other USB device connected to the
computer try to remove� 5) Repeat section Entering Programming Mode�
Start software download by pressing the green Start button� The downloading process takes about 2 minutes� Mean-
while MfgTool looks like this� The text information and the status bar in section A will change a few times during
software download�
82
SOFTWARE
Hide quick links:
Advertisement
Table of Contents
