Extron electronics RGB-DVI 300 User Manual page 32

6.
Select the device name, the connection method (which will be RS-232), the Com Port,
and the Baud Rate.
7. Click on the connect button.
When the connection is made, the name of the device appears, with a green check
mark, in the Connected Device box.
8. Click the Browse button and navigate to the folder where the firmware file was saved
(see step 4).
9.
Click Add button.
The Add Device box closes to reveal the main Firmware Loader window.
Figure 25.
Firmware Loader Main Window
10.
Click on the Begin button.
The firmware transfer takes approximately 3 minutes.
NOTE: During the firmware upload, the front panel LED and video output are
disabled.
11.
When the transfer is complete, the progress box reads 100% and the Status box reads
Complete.
RGB-DVI 300 and RGB-HDMI 300 (A) • Software and Firmware 26