Table of Contents
Advertisement
If the password is not entered correctly the panel will display as follows:
Once the current password has been entered, the panel will prompt for the configuration parameter being changed.
If the password has been lost:
→ Power down the DVP-120
→ Remove the Jumper Shorting Connector from the EXT header and place the Jumper Shorting Connector onto the top two pins of
the SYS header.
→ Power up the DVP-120. The first display is the current password on the unit.
→
Remove the Jumper Shorting Connector from the SYS header and install back onto the two bottom pins of the EXT header.
8.2 Configure Sensors Submenu
8.2.1
See section
4.1 Initial Operating Mode
8.2.2
See section
4.1.2 User Interface
8.2.3
See section
4.3 Setting the System Configuration
8.2.4
See section
4.3.3 Configure Sensors Submenu
Press Menu to display Hardware Summary
↑ x 2 Configure Sensors
Sensor
•
↑ Sensor type (set sensor type)
1=CO, 2=NO
, 3=EX, 4=NH
2
E n t e r
Figure A-9 Enter Password
W r o n g
Figure A-11 Wrong Password Prompt
for more detail
for more detail
S e n s o R
A :
2 0 0
Figure A-12 Sensor Summary
, 5=H
S, 6=REF, 7=CO
, 8=O
3
2
2
S e n s o r
T y p e : 1
Figure A-13 Sensor Type
P a s s w o r d
_ _ _ _
P a s s w o r d
for more detail
for more detail
0 1
W :
5 0
and 0=None
2
0 1
54
C O
C O
Advertisement
Table of Contents
