Table of Contents
Advertisement
When the first digit is entered, the panel will show
If the password is not entered correctly the panel will display
Once the current password has been entered, the panel will prompt for the configuration parameter being changed.
If the password has been lost:
Power down the DVP-120.
•
Remove the Jumper Shorting Connector from the EXT header and place the Jumper Shorting Connector onto the top two pins
•
of the SYS header.
Power up the DVP-120. The first display is the current password on the unit.
•
Remove the Jumper Shorting Connector from the SYS header and install back onto the two bottom pins of the EXT header.
•
Use only for monitoring the gases which the sensors and equipment are designed to monitor. Failure to do so may result in exposures
to gases not detectable and result in serious injury or death. For proper use, see supervisor or User Instructions, or call Macurco
Technical Service at 1-844-325-3050.
4.3.3
Configure Sensors Submenu
There is a list of parameters for each sensor in the system, either currently wired or configured but presently disconnected. The left and
right cursor keys can be used to move from one sensor to another and the up and down keys will scroll through the parameters for the
particular sensor.
4.3.3.1
Sensor Summary
This display example shows that the sensor on channel 01 has been configured as a Carbon Monoxide sensor with an Alarm level of
200ppm and a Warning level of 50ppm.
E n t e r
P a s s w o r d
_ _ _ _
Figure 4-24 Enter Password
E n t e r
P a s s w o r d
_ _ _ *
Figure 4-25 Password Prompt
W r o n g
P a s s w o r d
Figure 4-26 Wrong Password Prompt
WARNING
S e n s o r
0 1
A :
2 0 0
Figure 4-27 Sensor Summary
C O
W :
5 0
29
Advertisement
Table of Contents
