No Gsm Alarm; Cut Off Oil And Power System; Resume The Oil And Power System; Check The Vehicle State - Coban GPS105 User Manual

7.33. No GSM Alarm

When Vehicle enters GSM Blind area, the siren beeps in Non-quiet mode without sms sending if DOOR, SHOCK
SENSOR/ACC alarms are triggered.

7.34. Cut off oil and power system

7.34.1 Send SMS command "stop+password" to the GPS, it will reply "Stop engine Succeed" and remain the
immobile state until receiving the next SMS command to resuming the oil and power.
7.34.2 Stop Mode
7.34.3 Execute immediately: Send command "quickstop+password" to GPS, it will reply "quickstop OK". Then it will
stop the car immediately after "stop" command.
7.34.4 Execute depends on speed(Default mode): Send command "noquickstop+password" to tracker, It will reply
"noquickstop OK", Then the tracker won't stop the car immediately after "stop" command, instead, it will
reply "it will be executed after speed less than 20KM/H", and stop the car when the speed is less than
20KM/H.

7.35. Resume the Oil and Power System

Send "resume+password" to tracker, it will reply "Resume engine succeed", that means vehicle has resume the
oil supply.

7.36. Check the Vehicle State

Send SMS command "check+password" to the tracker device in the vehicle, It will reply the status of external
power, battery, GPS reception, ACC, door, GSM reception, GPRS and oil consumption to the
numbers.
For example: Send SMS "check123456" to the tracker device in the vehicle, it will reply following SMS after
executed the command.
Power: ON/OFF Battery: 100%
Door:OFF ACC:ON
GPS:OK
GPRS:OFF line
GSM Signal:21
Oil：65.5%

7.37. Reset Hardware

Send SMS "reset+password" to tracker device to reset the GSM module and GPS module of the tracker device, it
will reply "reset ok"
(1-32 the higher digit it shows; the stronger of GSM reception it receives.)
authorized