Table of Contents
Advertisement
Quick Links
1
GSM/GPRS/GPS Vehicle Tracker
GPS106A/B User Manual
Preface
Thank you for purchasing the tracker. This manual shows how to operate the device smoothly
and correctly. Make sure to read this manual carefully before using this product. Please note
that specification and information are subject to changes without prior notice in this manual.
Any change will be integrated in the latest release. The manufacturer assumes no
responsibility for any errors or omissions in this document.
Advertisement
Table of Contents
Related Manuals for Coban GPS106A
Summary of Contents for Coban GPS106A
- Page 1 GSM/GPRS/GPS Vehicle Tracker GPS106A/B User Manual Preface Thank you for purchasing the tracker. This manual shows how to operate the device smoothly and correctly. Make sure to read this manual carefully before using this product. Please note that specification and information are subject to changes without prior notice in this manual.
-
Page 2: Table Of Contents
Contents 1. Function Introduction ..........................4 2. Applications ..............................4 3. Hardware Description ..........................4 4. Acessories ..............................5 5．Specifications ............................6 6. Operating Instructions ..........................6 6.1 Terminal Installation ..........................6 6.2 SIM card installation..........................8 6.3 Turn on the tracker device ........................8 6.4 GSM/GPS LED Indicator ......................... - Page 3 6.23.4 Photograph ............................15 6.24. Silent Mode ............................15 6.25 Alarms in GSM Blind Area ........................16 6.26 Check the Vehicle State ........................16 6.27 Reset by SMS ............................16 6.28 Check IMEI ............................16 6.29 Terminal (local) Time Setting ....................... 17 6.30 GPRS Setting ............................
-
Page 4: Function Introduction
1. Function Introduction 1.1 This tracker is a new product based on the GSM / GPRS network and GPS satellite positioning system, which set multiple functions of security, positioning, monitoring surveillance, emergency alarms, photograph, fuel&temperature detection and tracking in its entirety. It can track and monitor remote target by SMS or internet. .2 Features 1.2.1 Support both GPS / GSM station positioning ways. -
Page 5: Acessories
⑴. GSM antenna connector. ⑺. Backup battery switch ⑵. J4 Monitor microphone jack. ⑻. GPS antenna connector ⑶. LED indicator ⑼. Remote control receiver antenna（model B） ⑷. SIM card slot ⑽. J1 12PIN harness port ⑸. SIM card slot Pop-up switch ⑾. -
Page 6: Specifications
Optional for Model A and B Camera Temperature Sensor Optional for Model A and B Optional for Model A and B and different type depends Fuel sensor on vehicles 5．Specifications Content Specifications 85*71*26mm Weight 170g Network GSM/GPRS Band 850/900/1800/1900Mhz GSM/GPRS Simcom900B Module GPS Module... - Page 7 6.1.1 Please ask the qualified engineers to install. 6.1.2 Do not install it in an environment which is over GSM performance and please pay attention to fix the antennas in a position with good signals. 6.1.3 Pay attention to make installation location preventing water and dust. 6.1.4 Find the 14PIN harness and insert it into the corresponding holes of the products, and connect the wires with the original car circuit showing below: Wiring diagram...
-
Page 8: Sim Card Installation
6.1.13 Connect the GPS and GSM antenna to the right connector, and find an appropriate place to fix the antennas to make sure good reception. 6.2 SIM card installation 6.2.1 Use a tweezers or a sharp thing to touch the SIM CARD popup switch, the SIM CARD slot will pop up, take out the SIM card slot to load the SIM card, and then put the SIM card slot back to its original position after confirm the SIM card in the right place. -
Page 9: Authorization
6.6.3 Note: The new password must be 6 digits of the Arabic numerals, or the device will not recognize. 6.6.4 Please don’t type “+” character in all commands, space means press the space keyboard on cell phone. 6.7 Authorization There are 5 numbers to be allowed to authorize in the tracker at most. 6.7.1 Call and track the tracker device for 10 times from cell phone in success, it will make the cell phone number as the authorized number automatically, and reply “add master ok”. -
Page 10: Get Location In Absolute Street Address
6.9.1 Send SMS command “fix030s005n+password” to the tracker device, it will report the Geo-info at 30s intervals for 5 times. (s:second, m:minute, h:hour). This command must be in 3 digits and the maximum value is 255. 6.9.2 Unlimited times track: Send SMS "fix030s*** n+password" to the device. 6.9.3 Cancel: Send SMS “nofix+password”... -
Page 11: Modes Switch Between "Track" & "Monitor
In this mode, the user can dial up the tracker device to monitor the voice around (please refer to 6.14.2 for instruction). 6.14 Modes switch between “track” & “monitor” 6.14.1 The default mode is “track” (track mode). 6.14.2 Send SMS command "monitor+password" to tracker device, it will reply " monitor ok!"... -
Page 12: Alarms
6.17. Alarms 6.17.1 Low battery alarm When the voltage of the tracker device is near 3.6V, it will send SMS “low battery+lat./long information” to the authorized numbers for two times. 6.17.2 Power off alarm When the external power of tracker be cut off or the voltage is 0V, it will send SMS “power alarm+lat./long.”... -
Page 13: Fuel Alarm
80km/h, the tracker will send SMS “speed+080!+latitude/longitude” to the authorized numbers in 3 minutes interval. Cancel: Send SMS “nospeed+password” to deactivate the overspeed alarm. Remark: The recommended speed should be not less than 30km/h. For below that rate, it will be effected the accuracy by GPS signals drift etc. 6.17.7 Fuel alarm If the tracker device detects the fuel decrease by 8% in three minutes, then it will send oil leak or theft alarm “oil: xx%+latitude/longitude”... -
Page 14: Arm
Succeed” and resume your car engine as well, at the same time. It will remain this state until receiving the next SMS command to cut off the oil and power system once receiving SMS command to resume the oil and gas system. 6.20 Arm 6.20.1 Set up arm by SMS Send SMS command “arm+password”... -
Page 15: Alarms Under Arm State
Long press “B” button for 3 seconds, device will send SOS alert to authorized phone numbers. 6.23. Alarms under Arm State 6.23.1 Door alarm The tracker will send SMS “Door alarm+lat/long” to the authorized numbers in 3 minutes interval when the door of the car opens in arm status; Siren will sound for 30 seconds, send disarm command “disarm+password”... -
Page 16: Alarms In Gsm Blind Area
after alarm is triggered, and tracker will also send SMS alarm to authorized numbers. 6.24.2 Set up Silent Mode by Remote Control (Option for model B) Press “A+B” together in disarm state for 0.5 second, the Silent mode siren will beep three time, no action from siren after alarm is triggered, but tracker will send alarm SMS to authorized numbers. -
Page 17: Terminal (Local) Time Setting
6.29 Terminal (local) Time Setting 6.29.1 Send SMS command “time+space+zone123456+space+time” to the tracker unit, If succeed, It will reply “time OK”. 6.29.2 For example: Send SMS “time zone123456 8”, 8 is Chinese time zone, If your country time zone is minus, send SMS “time zone123456 -8”. 6.30 GPRS Setting User must send SMS via cell phone to set up APN, IP and port before starting tracking by GPRS. -
Page 18: Modes Switch Between "Sms" And "Gprs
device, If succeeded, “adminip ok” is returned by the device in SMS. ( 123456 is default password，202.104.150.75 is IP，9000 is port). 6.34 Modes Switch between “SMS” and “GPRS” 6.34.1 The default mode is “SMS” 6.34.2 Send SMS “GPRS+password” to the unit, and it will reply “GPRS ok!” it means tracker device has switched to “GPRS”... - Page 19 In existence of an authorized number, an unauthorized number Hang up Fail dials up the unit. Please initialize the unit and re-set up the authorized numbers. Monitor Fail Check if the authorized number is setup...