Page 1
GSM/GPRS/GPS PORTABLE VEHICLE TRACKER USER MANUAL Preface Thank you for purchasing the tracker. This manual shows how to operate the device smoothly and correctly. Make sure to read this manual carefully before using this product. Please note that specification and information are subject to changes without prior notice in this manual.
Contents Introduction ............................ 3 1. Main Features ..........................3 2. Applications ..........................3 3. Hardware Description ........................3 Accessories ..........................5 Specifications .......................... 6 Installation and operating ........................ 6 1. Production installation ......................... 6 2. INT & EXT switch ........................7 3.
Page 3
22.2. Sleep by shock sensor ....................14 22.3 Deep Sleep by Shock Sensor ..................15 22.4 Start Work on specific time..................... 15 22.5 No sleep mode ....................... 15 IV. Alarm Function and settings ......................15 1. Geo-fence ..........................15 2 Multi-area management ......................16 3 Movement alarm ........................
I. Introduction This tracker is a new product based on the GSM / GPRS network and GPS satellite positioning system, which set multiple functions of security, positioning, monitoring surveillance, emergency alarms and tracking in its entirety. It can track and monitor remote target by SMS or internet. 1.
Page 5
LED Indicator EXT. GSM ANT EXT. GPS ANT 灯 3.3 Side face & antenna switch SIM Slot MicroSD Slot ON/OFF EXT. Power, Relay 3.4 Side face 3.5 Side face...
Built-in shock sensor Built-in Mic 4. Accessories Pictures Name Specs AC Adapter Input: AC 110-220V, Output DC: 1.5A,12V Lighter car adapter Car 12V OR 24V power 3 meters GPS Antenna 2 meters GSM Antenna Harness 4PIN 12V/40A 24V/40A Relay depends on the vehicle type...
Specifications Content specifications DIM. 94mm*60mm*38mm Weight 300g Network GSM/GPRS Band 850/900/1800/1900Mhz GPS sensitivity -159dBm GPS Accuracy Cold status GPS Start time Hot status EXT. power 12 V -24V Sleep Current 1.8mA Deep sleep 0.6mA Operating Current GSM operating Current 68mA±3mA GPRS Current(data transfer) 82mA±10mA Battery...
infiltration. If you need an external power supply, cut oil & power system and SOS feature, please find 4PIN main wire, wiring diagram as follows: Note: Please install SOS button on the hidden place driver can touch. 2. INT & EXT switch Switch to INT to change to use internal antenna;...
3.2 Please make sure that the SIM card is GSM network and able to execute the function of incoming calls display, no calls can be diverted and the PIN code is locked. The SMS format must be TXT format, and can’t recognize the PDU format. Battery Charging Please fully charge the product for the first use and charge as following: 4.1 Home charge:...
factory settings. (Default password is: 123456). For example: Send SMS "begin123456" to tracker, it will reply "begin ok". 3. Change Password Send SMS "password+old password+space+new password" to the tracker to change the password. For example: Send SMS "password123456 888888" to tracker, it will reply “password OK”, it means the password has changed successfully.
*Tracking location, when no GPS signal, the SMS includes the last valid latitude & longitude as well as the LAC code of current position, the LAC code can be input in the column of “manual track” menu of web platform. 6 Auto track continuously 6.1 Track with limited times upon time interval: Send SMS command “fix030s005n+password”...
changing driving direction over pre set angle value to form a smooth trajectory consistent with the actual road, this function is only effective in GPRS mode. 7.2 Send "angle+password+space+angle" to tracker, it will reply" angle ok". 7.3 The angle must be 3 digits Arabic numbers, default angle value is 30 degrees. 8.
GSM reception status. For example, send SMS “check123456”, and following information will be returned after execute the command: Power: Power off /charging/charge finish Battery: 100% GPS: OK/NO GPS GSM Signal: 1-32 (The higher digit it shows; the stronger of GSM signals it receives.) Check IMEI Send SMS "imei+password"...
depends on the SD card inserted. 15.6 The logged data in SD card can be copied to computers through card reader, and then the data route can be checked by importing data in the menu “Data Import” of web platform www.gpstrackerxy.com 16 Data Load 16.1 Current date Load: Send SMS: “load+password”...
tracker will stop the car immediately after “stop” command. Send command “stop+password” to tracker, tracker will execute it and reply “Stop engine Succeed”. And it will remain immobile state until next command to resume. 19.2. Execute depends on speed(Default mode) Send command “noquickstop+password”...
22.3 Deep Sleep by Shock Sensor Send "sleep+password+space+deepshock", tracker will reply "sleep deepshock ok" it will enter sleep mode if no vibration detecting, GPS & GSM module shut off, and LED will be off too. Only vibration can awake it, and tracker will send awake message automatically after wake up.
of the top left corner of the Geo-fence, while the second latitude & longitude is the coordinate of the bottom right corner 1.2 Cancel: Send SMS “nostockade+password” to deactivate this function. 2 MULTI-AREA MANAGEMENT 2.1 Set Area Send SMS command "area+password+space+latitude,longitude+space+areaname,distanceM"...
4. OVER SPEED ALARM 4.1 Over speed alarm will be triggered when tracker exceed the speed you setup. Setup: Send SMS “speed+password+space+speed” to tracker device and it will reply “speed ok!”, it means you have set up over speed alarm successfully. For example: “speed123456 080”...
deactivate. 9. Power off alarm 9.1 This function deactivate as default, send “ extpower+password+space+on” to activate, it will send SMS “power alarm+latitude/longtitude” to authorized numbers every 3 minutes when external power is cut off. 9.2 Cancel: Send SMS “ extpower+password+space+off” to deactivate it. 10.
compulsorily necessary, therefore, the entry can be skipped. For those countries requiring user name and password, please configure as following: Send SMS “up+password+space+user+space+password”, If succeeded, tracker will reply “user, password ok!”, for example: send SMS “up123456 jonnes 666666” Note: 123456 is password of tracker, jonnes is the user name for GPRS login, 666666 is the password for GPRS login.
centernum123456 13800138000. 2. Cancel: Send “nocenternum+password” to tracker, it will reply “no center num ok”. Cautions Don’t put the unit in overheated or overcooled places. Handle carefully. Don’t vibrate or shake it violently. Clear the unit with a piece of dry cloth. Don’t clean in chemicals, detergent. Don’t paint the unit, this may cause some foreign materials left in between the parts.
LED indicator status LED Indicator Status Red LED flash Low power Red LED ON Charging Power LED (Red) Red LED OFF Fully charged NO GSM reception GSM LED(Green) Quick flash for each second GSM Mode Slowly flash for each 3 seconds GPRS Mode No GPS reception GPS LED(Blue)...