Shock Sensor Alarm; Geo-Fence - Coban GPS302 User Manual

Gsm/gprs/gps tracker

Table of Contents

mode after the authorized number answer the call.

5.22. Shock Sensor Alarm

5.22.1 Setup: Shock sensor alarm is deactivated in default settings. If needed, please send SMS

"shock+password" to tracker device, and it will reply "Shock is activated!", it means shock sensor

SMS "Sensor

alarm has set up successfully. When the tracker detect vibration, it will send

alarm+Geo-info" to authorized numbers.

Note: Shock sensor detect vibration one time for each 3 minutes, it will start to detect the

second shock sensor alarm in 3 minutes after the first alarm.

5.22.2 Cancel: Send "noshock+password" to cancel the shock sensor alarm.

5.22.3 Shock sensor sensitivity configuration:

The sensitivity of the built-in shock sensor has three different level:

First

level:

Alarm

will be

triggered

after

detect

slight

vibration,

send

command"

sensitivity+password+space+1"

Second level: Alarm will be triggered after detect 8 times vibration in 2 seconds, send command"

sensitivity+password+space+2".

Third level: Alarm will be triggered after detect 25 times vibration in 5 seconds, send command"

sensitivity+password+space+3".

Set up a geo-fence for the unit to restrict its movements within a district. The unit will send the

message to the authorized numbers when it breaches the district.

5.23.1 Set up: When the unit stays immobile in a place for 3-10 minutes, the user can Send SMS:

"stockade+password+space+latitude,longitude; latitude,longitude" to unit to set the restricted district.

In case of breach, it will send SMS "stockade!+geo-info" to the authorized numbers

Note: The first latitude&longitude is coordinate of the top left corner of the Geo-fence, while the

second latitude&longitude is the coordinate of the bottom right corner.

Table of Contents