Page 1
.GSM/GPRS/GPS Vehicle Tracker GPS103-A/GPS103-B User Manual Preface Thank you for purchasing the tracker. This manual shows how to operate the device smoothly and correctly. Make sure to read this manual carefully before using this product. Please note that specification and information are subject to changes without prior notice in this manual.
1. Introduction This tracker is a new product based on the GSM / GPRS network and GPS satellite positioning system, which set multiple functions of security, positioning, monitoring surveillance, emergency alarms and tracking in its entirety. It can track and monitor remote target by SMS or internet. 2.
Voltage of car power 12 V-24V system Backup battery Chargeable changeable 3.7V 500mAh Li-ion battery Storage Temp. -40°C to +85°C Operation Temp. -20°C to +65°C Humidity 5%--95% non-condensing 5. Operating Instructions 5.1 Terminal Installation 5.1.1 Please ask the qualified engineers to install it. 5.1.2 Do not install it in a environment which is more than GSM performance, And please pay attention to fix the antennas in a exactly position with good signals.
Page 6
Wiring diagram 5.1.5 Note: The orange wire can be connected to the original car alarm horn; 5.1.6 Knowing about the type of the door trigger is positive or negative trigger. Please connect the green wire to the door control circuit if it is positive, and connect blue wire if it is negative.
tracker works normal. 5.4 GSM/GPS LED Indicator 5.4.1 Red LED indicator on: No GSM network signals. 5.4.2 Red LED indicator flash fast (one time each second): GSM Network signal is normally, and tracker works under GSM mode. 5.4.3 Red LED indicator flashes slowly (one time each three second): Tracker works under GPRS mode.
For example: send SMS “password123456 888888” to the unit. If succeeded, “PASSWORD,CONFIG OK” will reply to your cell phone from the device tracker. 6.2.2 Make sure the new password is in 6 digits, or else the tracker cannot recognize the password. 6.3 Authorization There are 5 numbers to be allowed to authorize in the tracker at most.
6.5 LBS Tracking: 6.5.1 You must set up the APN of your local GSM network for the SIM card in tracker first before using this function, if there is user name and password for GPRS login, Please refer to following to configure the APN, user name and password for GPRS login.
“lowbattery+ 6.7.1.2 This function disactivates as default, send SMS password+space+0” to deactivate. 6.7.2 Power off alarm 6.7.2.1 Send “extpower+password+space+1” to activate, it will send SMS “power alarm+latitude/longtitude” to authorized numbers when external power is cut off. 6.7.2.2 This function disactivates as default. Cancel: Send SMS “extpower+ password+space+0”...
represents enter fence alarm; 3 represents out and enter fence alarm. 6.7.5.1 Set up: “stockade+password+space++semi-diameter+alarm the user can send SMS type” to unit to set the restricted district. In case of breach, it will send SMS “stockade!+geo-info” to the authorized numbers. For example: send SMS “stockade000000 500 1”...
30km/h.For below that rate; it may cause the excursion of the GPS signal influenced by clouds etc. 6.7.8 ACC working alarm 6.7.8.1 This function is disabled as default. To active this functions, send "ACC+password+1" to tracker, it will reply "ACC,CONFIG OK". And tracker will send "ACC on+latitude &...
the vehicle. It will reply “DOOR,CONFIG OK” in both armed and disarmed state, and the SMS command will make the tracker device enter into armed state if the unit currently disarmed. 6.10.1.2 User must stop the engine, (that is ACC is lower voltage).Sending SMS “DOOR+password+1”...
to quit. 6.12 Disarm 6.12.1 Disarm by SMS Send SMS command "DOOR+password+0" to the tracker device in the vehicle, It will reply “DOOR,CONFIG OK” in both armed and disarmed state, and the SMS command will make the tracker device enter into disarmed state if the unit currently armed.
sound after alarm is triggered, but tracker will send alarm SMS to authorized numbers. Quit silent mode:Press to quit 6.14 Switch between GPRS and SMS Mode Send SMS “GPRS+password+1” to tracker device to switch to GPRS mode; Send SMS “GPRS+password+0” to tracker device disable GPRS mode. Both will reply “GPRS,CONFIG OK”.
6.16 Device Resetting 6.16.1 SMS Reset Send SMS “reset+password” to tracker device to reset the GSM module and GPS module of the tracker device, it will reply “reset ok”. 6.17 IMEI Checking 6.17.1 Send SMS command "getimei+password" to the unit. E.g. Send SMS command "getimei123456"...
to UDP mode. Send SMS Command:"UDP+password+0" switch off UDP mode. 6.20 GPRS Setting User must send SMS via cell phone to set up APN, IP and port before starting tracking by GPRS on tracking system. 6.20.1 Setting up APN 6.20.1.1APN standards for Access Point Name and differs from country to country.
6.21 Set up monitor center number 6.21.1 Setup: send command “centernum+password+space+number” to tracker, it will reply“centernum ok”. After setup monitor center number, the messages of auto track by sms will be set to this center number, if all alarms need to be sent to this number too, then this center number must be setup as authorized number.
something more about the voltage range. Otherwise, it won’t work properly or destroy the product. 8. Faults & the Solutions Faults Solution Startup Fail Please check out the power wiring in correct place. Call Fail Check the GSM antenna connected. Check whether the SIM card in place.