Multi-Area Management; Movement Alarm; Over Speed Alarm - Coban GPS105 User Manual

Gsm/gprs/gps vehicle tracker

Table of Contents

the fence.

Cancel: Send SMS "nostockade+password" to deactivate this function.

7.29.3. Multi-area management

7.29.3.1 Set Area

Send SMS command "area+password+space+latitude,longitude+space+areaname,distanceM" to tracker(distance

unit: M for meter, K for kilometer), it will reply "area01 ok".

Example: Send "area123456 22.353648,113.543678 school,800M".

Note: 5 areas at most and the distance between two points can't be less than the total distance in the 2 commands,

and different areas can't cover each other.

7.29.3.2 Delete areas

Send SMS command:"noarea+password+space+area name", tracker will reply:"noarea ok".

7.29.3.3 Rename and set distance

Send SMS command "rename+password+space+old name;new name,distanceM" to tracker, if name is not

repeated and area doesn't cover others, it will reply "rename ok!" for successful configuration.

Example: Send"rename123456 area01;school,800M", it means the new area name is "school", and covers area of

a radius of 800 meters.

7.29.3.4 Activate multi-area management

Send SMS command "area+password+space+on" to tracker, it will reply "Area on ok!", when tracker enter the

pre set area, it will send SMS "area name+latitude & longitude" to all the authorized phone number, and send

same SMS when goes out of the area.

7.29.3.5 Deactivate Multi-area management

Send SMS command "area+password+space+off" to tracker, it will reply"area off ok!"

Set up: when the unit stays immobile in a place for 3-10 minutes with GPS signal reception, the user can send

SMS"move+password+space+0200" to the tracker (Suppose area of a radius of 200 meters, it supports 4 digits at most.

Unit: Meter). It will reply "move OK". In case of such a movement (the default distance is 200m), it will send SMS

"Move+ latitude & longitude" to the authorized

Cancel: Send SMS "nomove+password" to deactivate the movement alarm.

7.29.5.1.Set up: Send SMS "speed+password+space+080" to the unit (suppose the speed is 80km/h), and it will

reply "speed OK!". When the target moves exceeding 80km/h, the unit will send SMS "speed+080!+ latitude &

longitude" to the authorized numbers.

7.29.5.2.Cancel: Send SMS "nospeed+password" to deactivate the over speed alarm.

numbers.

Table of Contents