Auxiliary Channels; Marker Out; Trigger In - Teledyne T3AWG2152 Operator's Manual

Auxiliary Channels

Marker Out

The Marker Out generates a digital pulse synchronous with the waveform or with the modulating
function depending on the Run Mode. To set the Marker Out parameters refer to the Channel Settings.

Trigger In

The TRIGGER IN connector allows to control the signal generation when a channel is in Burst Run Mode
or in Sweep Run Mode. Refer to the chapters about the Device Settings to know how to define the
trigger parameters or the Run Mode. In Continuous and Modulation Run Modes the Trigger In doesn't
have any effects.
Trigger In signal (blue, top) that starts a burst of sine waveform (red, bottom)
Marker Out Specification Value
Connector
Output impedance
Output level (into 50 Ω)
Marker out (blue, top) synchronous with the analog signal (red, bottom)
Trigger In Specification Value
Connector
Input impedance
Slope/Polarity
Operator's Manual Simple AFG Application
1 BNC on the Front Panel
50Ω
1V to 2.5V
1 BNC on the Front Panel
1kΩ or 50Ohm selectable
Positive or negative selectable
36