Numeric Keypad - Teledyne T3AWG2152 Operator's Manual

Button Description
HOME If you are in a sub-menu page, use this button to return to the main page.
TRIGGER Use this button to send an internal trigger to the instrument.
RUN Use this button to start and stop the signal generation. If the button is on and
green the instrument is running while if it is off the instrument is stopped. Bushing
the button will change the instrument state.
LEFT ARROW Once the virtual numeric keypad will be opened, use this button to move to the
left the digit selection cursor.
RIGHT ARROW Once the virtual numeric keypad will be opened, use this button to move to the
right the digit selection cursor.
TOUCH SCREEN Use this button to disable the touch screen.
OFF
AMPL./V HIGH Use this button to set the high voltage level or the amplitude of the waveform.
FREQ/PERIOD Use this button to set the period or the frequency of the waveform.
AWG <-> AFG Use this button to switch between AFG mode and AWG operating mode.
OFFSET/V LOW Use this button to set the low voltage level or the offset of the waveform.
PHASE/DELAY N.A.
SETTINGS Use this button to open the Settings page
CHANNEL SEL. Use this button to change the output selection in the user interface
ALL OFF Use this button to turn off all the outputs.
DEFAULT Use this button to restore the default settings.

Numeric Keypad

The physical numeric keypad lets you to set the parameter value and their measure unit.
Once a parameter to be edited is selected by using the touch panel or the soft keyboard, each number
pressed in the keypad will be shown in the display. The Bksp key is provided for deleting erroneous key
presses. The [+/-] key will toggle the sign of the number being entered and may be pressed after
terminating the entry. After the sign and the numeric portion of the desired value have been entered,
the pressing of the multiplier button applies the parameter. The Enter button closes the virtual keyboard
and will apply the entered value.
Operator's Manual Simple AFG Application
18