Table of Contents
Advertisement
Import File Specifications
Accepted Formats
Length Range
Offset and Amplitude
Range
The Import page is divided into three areas: the Graph Area, the Waveform List and the Button Area.
Below a detailed description of these areas is provided.
Graph Area: shows preview of the waveform. A waveform is selected by touching the checkbox in the
graph. The selected waveform than can be assigned to the Carrier or Modulation Wave or Sweep Profile
of the channel by touching one of the 3 buttons (Carrier button, Modulation button, Sweep button) in
the Button Area located on the right side of the "Upload to..." label.
Waveform List: This section contains a list of all the predefined and imported waveforms.
•
The Trash Bin
waveform.
•
The Multiple Select Enable
waveforms to be deleted. If multiple waveforms are selected for import only the first one is
imported.
Button Area: It is composed by 4 buttons:
Description
.txt (Tab Separated text), .csv(Comma Separated Value), .trc (LeCroy
Digital oscilloscope)
Between 2 and 16384 samples. The instrument memory is limited at
16 k sample (16384) for each arbitrary waveform. If a longer
waveform is imported it will be resampled to match the maximum
length.
When a waveform is imported from a file its original amplitude and
offset are lost because the waveform in normalized during the
importing process. Anyway the amplitude and offset of the
normalized waveform can be redefined as for any predefined
waveforms.
deletes the selected waveforms. It is not possible to delete a predefined
Operator's Manual Simple AFG Application
checkbox enables the selection of multiple
59
Advertisement
Table of Contents
