Run Command; Selecting The Run Command Source - YASKAWA CIMR-MX1S Instructions Manual

Run Command

This section explains input methods for the Run Command.

Selecting the Run Command Source

Set constant b1-02 to select the source for the Run Command.
Related Constants
Constant
Number
b1-02
Performing Operations Using a Digital Operator
When b1-02 is set to 0, you can perform Matrix converter operations using the Digital Operator keys (RUN,
STOP, JOG, and FWD/REV). For details on the Digital Operator, refer to Chapter 3 Digital Operator and
Modes.
Performing Operations Using Control Circuit Terminals
When b1-02 is set to 1, you can perform Matrix converter operations using the control circuit terminals.
-4
6
Name
Description
Display
Sets the Run Command input
Operation method
method.
selection
0: Digital Operator
1: Control circuit terminal
(sequence input)
2: MEMOBUS communica-
Run Source
tions
3: Built-in PLC
Change
Setting Factory
during
Open-
Range Setting
Operation
loop
Vector
0 to 3 3 No
Control
Methods
MEMOBUS
Register
Flux
Vector
Q Q 1A1H