nifty Heightrider HYBRID Series Operating/Safety Instructions Manual page 41

GEARBOX DISENGAGEMENT (TYPE 2)
The drive gearboxes located on the front and rear wheel hubs must be disengaged as follows;
1) Remove both retaining bolts that secure the cover disc to the centre of the wheel hub.
2) Partially screw one of the retaining bolts into the end of the central disengage pin and pull the pin
out fully, ensuring the recess on the pin is visible.
3) Place the cover disc over the pin, ensuring the retaining disc is engaged in the pin recess and
secure in place using the remaining retaining bolt.
4) To re-engage the gearbox, complete the above instructions in reverse order, ensuring gearbox
drive is free to engage before pushing the pin 'home'. If necessary, jack up each wheel & rotate
slightly to allow re-engagement of pin.
4.7.3 CRANEAGE
1) Observe all of the limitations relating to straps and chains stated above under 'Transporting'.
(4.7.1)
2) When utilising the designated lifting points never apply a 'snatch' load, i.e. lift slowly to take up
the load before raising. Similarly, do not drop machine when positioning after lifting.
3) If the machine is to be lifted by crane, use the designated lifting points and observe the
recommendations regarding spreader beams. Individual drawings are available for each machine
type, on request. (See list below.)
English/USA – 04/14
Original instructions
D80461
D81790
D80935
D81301
D80938
Height Rider/SP Series
Operating & Safety Instructions
HR10/12
HR15/17 4x4/Hybrid Mk2
HR15N
HR17N
HR21
39