nifty Heightrider HYBRID Series Operating/Safety Instructions Manual page 25

Note; During normal machine usage with the engine running, the batteries are on continuous recharge
The exception to this is when the control system decides that additional electric power is required in
order to maintain drive/function speed. If the operator is using electric power only and a low battery
warning has activated, it is advisable to start the engine, enabling continued use of the machine, whilst
at the same time recharging the batteries.
BATTERY ISOLATOR: - The battery-disconnect button is located adjacent to the left hand battery pod
on the chassis. In order to isolate the machine control and power circuits from the batteries it is
necessary to press this button, which disconnects the supply to the entire control system. Under
normal operation, the machine key switch should be used to isolate the machine, with the battery
isolator button only being required for emergencies, in the event of a short circuit, or during routine
maintenance.
4.1.5 FUSES & TRIP SWITCHES: -
Power Tray
35A Circuit breaker inside ABS box
Ground Control Station
125A Fuse on Ground Control Tray
80A Fuse on Ground Control Tray
(If auxiliary descent pump is fitted)
2 x 15A blade fuses inside Ground Control Box
1 x 2A blade fuse inside Ground Control Box
1 x 15A Circuit breaker
1 x 10A Circuit breaker
English/USA – 04/14
Original instructions
Height Rider/SP Series
Operating & Safety Instructions
Chassis
325A Fuse inside base
Platform Control Station
2 x 15A blade fuses behind Control Panel
2 x 2A blade fuses behind Control Panel
23