nifty Heightrider HYBRID Series Operating/Safety Instructions Manual page 11

2.1.8
This machine contains several hazardous substances such as but not limited to: Battery acid, Hydraulic
Fluid, Engine Coolant, Antifreeze, LPG, Diesel Fuel, Petrol, Engine Oil, Grease, Gasoline.
2.1.9
Covers and canopies should remain closed when the machine is in operation. Only trained personnel
should carry out maintenance on the machine, ensuring at all times they protect themselves from
electrical, heat and mechanical hazards.
2.1.10
Never exceed the maximum platform capacity, as indicated on the decals and machine serial plate.
2.1.11
Only operate the Niftylift on a firm, level surface.
2.1.12
Never position any part of the Niftylift within 4.0m, (12ft) of any electrical power line, conductor or
similar not exceeding 66kV. (Minimum span 125m) Other distances for increased voltages and
different spans are given in NZECP 34:1993.
2.1.13
On entering the platform ensure that the drop down entry bar is closed afterwards.
2.1.14
Use of an approved safety belt and lanyard, hard hat and appropriate safety clothing is mandatory.
Fasten harness to designated harness securing points within the platform and do not remove until
leaving the platform whilst in the stowed position.
2.1.15
2.1.16
Do not use the platform levelling system to artificially increase the outreach of the platform. Never use
boards or ladders in the platform to achieve the same result.
2.1.17
Do not use the platform to lift overhanging or bulky items that may exceed the maximum capacity or
carry objects that may increase the wind loading on the platform. (e.g. Notice boards etc.)
2.1.18
The Niftylift shall not be operated from a position on trucks, trailers, railway cars, floating vessels,
scaffolds or similar equipment unless the application is approved in writing by Niftylift Ltd in Great
Britain.
2.1.19
Always check that the area below and around the platform is clear of personnel and obstructions
before lowering or slewing. Care should be taken when slewing out into areas where there may be
passing traffic. Use barriers to control traffic flow or prevent access to the machine.
2.1.20
Stunt driving and horseplay, on or around the Niftylift, shall not be permitted.
2.1.21
When other moving equipment and vehicles are present, special precautions shall be taken to comply
with local ordinances or safety standards established for the work place. Warnings, such as but not
limited to, flags, roped off areas, flashing lights and barricades shall be used.
2.1.22
Before and during driving while the platform is elevated the operator shall maintain a clear view of the
path of travel, maintain a safe distance from obstacles, debris, drop offs, holes, depressions, ramps
and other hazards to ensure safe elevated travel. Maintain a safe distance from overhead obstacles.
English/USA – 04/14
Original instructions
THIS MACHINE IS NOT INSULATED.
If in doubt, contact the appropriate authorities
Always remain standing within the platform. Do not attempt to increase your height or
reach by standing and/or climbing on the platform guard rails or any other object.
KEEP YOUR FEET ON THE PLATFORM FLOOR. Do not sit, stand or climb on the
guard rail, mid rail or boom linkage. Use of planks, ladders or any other devices on
the Niftylift for achieving additional height or reach shall be prohibited.
Height Rider/SP Series
Operating & Safety Instructions
9