Table of Contents
Advertisement
Chapter 3 Basic Operations — Switching on/off the projector
10) Press as to select [STORE], and press the <ENTER> button.
f The confirmation screen is displayed.
11) Press qw to select [OK], and press the <ENTER> button.
Note
f For limitation of the character string that can be set as a password, refer to "[PASSWORD POLICY]" (x page 68).
f Pressing the <MENU> button while the [ADMINISTRATOR ACCOUNT] screen is displayed enables to advance to the next operation
without setting the password of the administrator account but network function of the projector will not be able to be used. When using the
web control function or the communication control via LAN (including operation by application software), set a password.
f When pressing the <MENU> button while the [ADMINISTRATOR ACCOUNT] screen is displayed, the [ADMINISTRATOR ACCOUNT]
screen will not be displayed from the next time the projector is switched on. To use the network function, set a password in the [NETWORK]
menu → [ADMINISTRATOR ACCOUNT].
f The user name and password of the administrator account can also be changed in "[Set up password] page (when accessed by
administrator account)" (x page 214) of the web control screen.
f The user name and password of the standard user account without administrator rights can be set in "[Set up password] page (when
accessed by administrator account)" (x page 214) of the web control screen.
Making adjustments and selections
It is recommended to perform the focus adjustment after 30 minutes have elapsed with the focus test pattern
displayed. For details of the test pattern, refer to "[TEST PATTERN] menu" (x page 178). To use the active focus
optimizer function, set the [PROJECTOR SETUP] menu → [LENS] → [ACTIVE FOCUS OPTIMIZER] → [ACTIVE
FOCUS] to [ON], and then adjust the focus. (x page 149)
1)
Press the <FOCUS> button to roughly adjust the focus of the projected image. (x page 72)
2)
Change the setting of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on the
installation mode. (x page 34)
f Refer to "Navigating through the menu" (x page 86) for the operation of the menu screen.
3)
Set [LENS TYPE].
f Confirm the setting of the lens type when using the projector for the first time after attaching the projection
lens. (x page 74)
4)
Execute the lens calibration.
f Execute the lens calibration when using the projector for the first time after attaching the projection lens.
(x page 74)
5)
Press the input selection button (<RGB1>, <RGB2>, <DIGITAL LINK>, <DVI-D>, <HDMI>, <SDI>, <SDI
1/2>) to select the input signal.
6)
Adjust the front, back and sideway tilt of the projector with the adjustable feet. (x page 49)
7)
Press the <SHIFT> button to adjust the position of the projected image.
8)
If the input signal is the analog RGB signal or the DVI-D/HDMI signal, press the <AUTO SETUP>
button.
9)
Press the <ZOOM> button to match the projected image size to the screen.
10) Press the <FOCUS> button again to adjust the focus.
5)
6)
8)
2) 3) 4)
1) 7) 9) 10) 11)
1) 10)
8)
ENGLISH - 69
5)
2) 3) 4)
7)
9) 11)
Advertisement
Table of Contents
