Table of Contents
Advertisement
6)
Press qw to switch the item.
f The items will switch each time you press the button.
[CHROMA ONLY]
[LUMINANCE/CHROMA]
Note
f When [GEOMETRY LINKED] is selected, set the projection method and perform geometric adjustment, and then correct the uniformity.
[SHUTTER SETTING]
The operation of the shutter function is set.
Setting [MECHANICAL SHUTTER]
1)
Press as to select [SHUTTER SETTING].
2)
Press the <ENTER> button.
f The [SHUTTER SETTING] screen is displayed.
3)
Press as to select [MECHANICAL SHUTTER].
4)
Press qw to switch the item.
[ENABLE]
[DISABLE]
Note
f By closing the mechanical shutter, the malfunction of the DLP chip caused by high power laser ray entering the projection lens surface can
be prevented. To close the mechanical shutter, set [MECHANICAL SHUTTER] to [ENABLE] and then set the shutter function to be enabled
(shutter: closed).
f When [MECHANICAL SHUTTER] is set to [ENABLE], it will take approximately 0.5 seconds from when the shutter function is enabled
(shutter: closed) to the shutter function is disabled (shutter: opened).
f The light source may turn on darker to warm up when the shutter function is used when the operating environment temperature is around
0 °C (32 °F) when [MECHANICAL SHUTTER] is set to [DISABLE].
Setting [FADE-IN] or [FADE-OUT]
Set the image fade-in and fade-out when the shutter function operates.
1)
Press as to select [SHUTTER SETTING].
2)
Press the <ENTER> button.
f The [SHUTTER SETTING] screen is displayed.
3)
Press as to select [FADE-IN] or [FADE-OUT].
4)
Press qw to switch the item.
[FADE-IN]
[FADE-OUT]
Note
f Press the <SHUTTER> button on the remote control or the control panel during fade-in or fade-out to cancel the fade operation.
Setting [STARTUP]
Automatically enable/disable the shutter function (shutter: closed/opened) when the power is turned on.
1)
Press as to select [SHUTTER SETTING].
138 - ENGLISH
Chapter 4 Settings — [DISPLAY OPTION] menu
Corrects only the color unevenness. Select this item to prioritize the brightness of the whole projected
image.
Corrects the brightness unevenness and the color unevenness.
Closes the mechanical shutter when the shutter function is enabled (shutter: closed).
Leaves the mechanical shutter opened and turns off the light source when the shutter function is
enabled (shutter: closed).
Item
[OFF]
[0.5s] - [10.0s]
Adjustment
Does not set fade-in or fade-out.
Sets the fade-in or fade-out time.
Select an item from [0.5s] - [4.0s], [5.0s], [7.0s], or [10.0s]. [0.5s] -
[4.0s] can be selected in increments of 0.5.
Advertisement
Table of Contents
