Table of Contents
Advertisement
5)
Press as to select [NOTIFIED IP ADDRESS 1] or [NOTIFIED IP ADDRESS 2].
f Enter the IP address of the computer to be notified of the status of the projector.
[Art-Net]
Set the Art-Net function.
f To use the Art-Net function with the projector, it is necessary to set the password of the administrator account.
(x page 190)
Note
f When a password is not set for the administrator account (when blank), the network function of the projector cannot be used. When using
the web control function or the communication control via LAN (including operation by application software), set a password.
[Art-Net SETUP]
Make settings to use the Art-Net function.
1)
Press as to select [Art-Net].
2)
Press the <ENTER> button.
f The [Art-Net] screen is displayed.
3)
Press as to select [Art-Net SETUP].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON(2.X.X.X)]
[ON(10.X.X.X)]
[ON(MANUAL)]
f Proceed to Step 5) when anything other than [OFF] is selected.
5)
Press the <ENTER> button.
f The [Art-Net SETUP] screen is displayed.
6)
Press as to select an item, and press qw to switch the setting.
[NET]
[SUB NET]
[UNIVERSE]
[START ADDRESS]
7)
Press as to select [STORE], and press the <ENTER> button.
f The confirmation screen is displayed.
8)
Press qw to select [OK], and press the <ENTER> button.
Note
f If [ON(2.X.X.X)] or [ON(10.X.X.X)] is selected, IP address is calculated and set automatically.
Chapter 4 Settings — [NETWORK] menu
Disables the Art-Net function.
Enables the Art-Net function and sets the IP address to 2.X.X.X.
Enables the Art-Net function and sets the IP address to 10.X.X.X.
Enables the Art-Net function and uses the IP address set in [WIRED LAN].
Enter [NET] to be used when the projector processes Art-Net.
Enter [SUB NET] to be used when the projector processes Art-Net.
Enter [UNIVERSE] to be used when the projector processes Art-Net.
Enter [START ADDRESS] to be used when the projector processes Art-Net.
ENGLISH - 193
Advertisement
Table of Contents
