Table of Contents
Advertisement
3)
Press a to stop on any part of the screen to be the first just focus point.
f For the location where focus is shifted in this state, the just focus point is on the inner side of the screen.
4)
Loosen the fixed screws in the position relative to the location where the focus is shifted the most
(the location where the just focus point is shifted the most towards the inner side in Step 2)) up to
one and half rotations.
f Turn screws clockwise in two locations, or at least in one location when making an adjustment.
5)
Slowly turn the focus adjustment screws corresponding to the locations counterclockwise and stop
where the image is in focus. (x page 79)
f If the screws are turned counterclockwise, the tilt of the lens will change by moving the lens mount bracket
of the lens mounter forward (screen side), and in the projected image on the screen, the focus point in the
opposite direction of the adjustment screws will move from the inner side of the screen to the outside.
6)
Press the <SHIFT> button on the remote control or the <LENS> button on the control panel to display
the lens shift adjustment menu, and reset the screen position of the projected image on the screen
surface back to an optimal state.
7)
Perform focus adjustment again near the center of the screen and if it is still not enough, fine tune the
amount of rotation of the adjustment screws.
8)
When adjustments have been made, securely tighten the loosened fixing screws.
9)
Adjust the focus again using the remote control.
80 - ENGLISH
Chapter 3 Basic Operations — Projecting
Advertisement
Table of Contents
