Table of Contents
Advertisement
r Radio wave for wireless LAN communication does not go through the reinforcing
bars, metal, or concrete.
The projector can communicate through wall or floor made of wood or glass (excluding the glass with metal mesh
embedded), but it cannot communicate through wall or floor made of reinforcing bars, metal, or concrete.
r Do not use the projector as much as possible in a location where static electricity is
generated.
The communication via wireless LAN or wired LAN may be prone to disruption when the projector is used in a
location where static electricity or noise is generated.
There is a rare case that the LAN connection may not be established due to static electricity or noise, so in such
case, turn off the projector, remove the source of problematic static electricity or noise, and turn the projector back
on.
QUAD PIXEL DRIVE
"QUAD PIXEL DRIVE" is a technology unique to Panasonic Connect Co., Ltd. that will enhance the resolution of
the projected image with the signal processing for the high resolution of up to 3 840 x 2 160 dots and quadrupling
the resolution by shifting the image pixels in horizontal and vertical directions. A 4K image is displayed by this
QUAD PIXEL DRIVE technology.
DIGITAL LINK
"DIGITAL LINK" is a technology to transmit the video, audio, Ethernet, and serial control signals using a twisted
pair cable by adding unique functions by Panasonic Connect Co., Ltd. to the HDBaseT
formulated by HDBaseT Alliance.
This projector supports the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G,
ET-YFB200G) and peripheral devices by other manufacturers (twisted-pair-cable transmitters such as the "XTP
transmitter" of Extron Electronics) that use the same HDBaseT
that the operation has been verified with this projector, visit the website (https://panasonic.net/cns/projector/). Note
that the verification for devices of other manufacturers has been made for the items set by Panasonic Connect
Co., Ltd., and not all the operations have been verified. For operation or performance problems caused by the
devices of other manufacturers, contact the respective manufacturers.
Art-Net
"Art-Net" is an Ethernet communication protocol based on the TCP/IP protocol.
By using the DMX controller and the application software, illumination and stage system can be controlled. Art-Net
is made based on DMX512 communication protocol.
Application software supported by the projector
The projector supports following application software. For details or downloading application software other than
the "Geometric & Setup Management Software", visit the website (https://panasonic.net/cns/projector/).
f Logo Transfer Software
This application software transfers the original image, such as company logo, which is projected at the start, to
the projector.
f Multi Monitoring & Control Software
This application software monitors and controls the multiple display devices (projector and flat panel display)
connected to an intranet.
f Early Warning Software
This plug-in software monitors the status of the display devices and their peripherals within an intranet, and
notifies of abnormality of such equipment and detects the signs of possible abnormality. "Early Warning
Software" is preinstalled in the "Multi Monitoring & Control Software". To use the early warning function of
this plug-in software, install "Multi Monitoring & Control Software" in the PC to be used. By enabling the early
warning function, it will notify of the approximate time to replace the consumables for the display devices,
to clean each part of the display devices, and to replace the components of the display devices, allowing to
execute maintenance in advance.
The early warning function can be used by registering maximum of 2048 display devices free of charge for
90 days after installing the "Multi Monitoring & Control Software" into a PC. To continuously use after the 90
days, it is necessary to purchase the license of "Early Warning Software" (ET-SWA100 Series) and perform
Chapter 1 Preparation — Precautions for use
TM
TM
standard. For the devices of other manufacturers
communication standard
ENGLISH - 23
Advertisement
Table of Contents
