Table of Contents
Advertisement
f Microwave oven, etc.
f Industrial, scientific, or medical devices, etc.
f In-plant wireless station for identifying moving vehicles used in the manufacturing lines at a plant
f Specified low power wireless station
rDo not use cell phone, television, or radio as much as possible close to the projector.
Cell phone, television, or radio is using radio wave with different bandwidth from the projector, so there is no effect
on the wireless LAN communication or the send/receive on these devices. However, noise may occur in the audio
or video due to the radio wave from the projector.
rRadio wave for wireless LAN communication does not go through the reinforcing
bars, metal, or concrete.
The projector can communicate through wall or floor made of wood or glass (excluding the glass with metal mesh
embedded), but it cannot communicate through wall or floor made of reinforcing bars, metal, or concrete.
rDo not use the projector as much as possible in a location where static electricity is
generated.
The communication via wireless LAN or wired LAN may be prone to disruption when the projector is used in a
location where static electricity or noise is generated.
There is a rare case that the LAN connection may not be established due to static electricity or noise, so in such
case, turn off the projector, remove the source of problematic static electricity or noise, and turn the projector back
on.
DIGITAL LINK
"DIGITAL LINK" is a technology to transmit the video, audio, Ethernet, and serial control signals using a twisted
pair cable by adding unique functions by Panasonic Connect Co., Ltd. to the HDBaseT
formulated by HDBaseT Alliance.
This projector supports the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G,
ET-YFB200G) and peripheral devices by other manufacturers (twisted-pair-cable transmitters such as the
"XTP transmitter" of Extron Electronics) that use the same HDBaseT
manufacturers that the operation has been verified with this projector, visit the following website.
https://panasonic.net/cns/projector/
Note that the verification for devices of other manufacturers has been made for the items set by Panasonic
Connect Co., Ltd., and not all the operations have been verified. For operation or performance problems caused
by the devices of other manufacturers, contact the respective manufacturers. The projector is not equipped with
an audio function so it is not possible to output audio.
Art-Net
"Art-Net" is an Ethernet communication protocol based on the TCP/IP protocol.
By using the DMX controller and the application software, illumination and stage system can be controlled. Art-Net
is made based on DMX512 communication protocol.
Application software supported by the projector
The projector supports following application software.
For details or downloading application software except for "Geometric & Setup Management Software" and
"Projector Network Setup Software", visit the following website.
https://panasonic.net/cns/projector/
"Geometric & Setup Management Software" and "Projector Network Setup Software" can be downloaded from the
following website ("Panasonic Professional Display and Projector Technical Support Website").
https://panasonic.net/cns/projector/pass/
It is necessary to register and login to PASS
Technical Support Website".
*1 PASS: Panasonic Professional Display and Projector Technical Support Website
f Logo Transfer Software
This application software transfers the original image, such as company logo, which is projected at the start, to
the projector.
f Smart Projector Control
This application software sets and adjusts the projector connected via LAN using a smartphone or a tablet.
24 - ENGLISH
Chapter 1 Preparation — Precautions for use
to download from "Panasonic Professional Display and Projector
*1
communication standard
TM
standard. For the devices of other
TM
Advertisement
Table of Contents
