Table of Contents
Advertisement
Setting the Tone
playing.
The
tape player automatically begms playing the
other side when it reaches the end of the tape.
EQUALIZER:
A seven band equalizer is part of your
audio system. Slide the levers up
to
boost or down to
reduce frequency range.
If E and a number appear on the radio display, the tape
won't play because of
an
error.
Adjusting the Speakers
BAL:
Press
this
knob lightly so it extends. Turn it to
1
.%
open end down and
try
to
turn the
right
hub
@
.
ElO:
The tape
is
tight and the player can't turn the
.,$,,
tape hubs. Remove'the tape. Hold the tape with the
.
-.
. ,
).
.
I
move the sound to the left or right speakers. Use the
middle position to balance these speakers. Push the knob
back in when you're
not
using it.
FADE:
Press this knob lightly so it extends.
Turn
it to
move the sound
to the
front
o r rem speakers. Use
tbe
middle position to balance these speakers. Push the knob
back in when you're not using it.
Playing a Cassette Tape
Your tape player is built to work best with tapes that are
30 to 45 minutes long on each side. Tapes longer than
that are so thin they may not work well in this player.
While the tape is playing, use the
VOL,
F m E and BAL
controls just as you do for the radio. The dispiay will show
an arrow to show which side of the tape is playing. When
the dawn indicator arrow is
lit,
selections listed on the
bottom side of the cassette are playing. When the up mow
is fit, selections listed on the top side
of the cassette
are
counterclockwise
with a
pencil.
T u r n
the tape over
and repeat. If the hubs do not turn easily, your tape
may
be
damaged and should not be used in the
player. Try a new tape to make sure your player is
working properly.
Ell: The tape is broken.' Try a new tape.
If any error occurs repeatedly or if an error can't be
corrected, please contact your dealer. If your radio
displays an error number, write it down and provide it to
your dealer when reporting the problem.
PREV (1):
Press this button or the SEEK down arrow to
search for the previous selection on the tape. Your tape
must have at least three seconds of silence between each
selection for PREV or SEEK to work. "he tape direction
arrow blinks during PREV or SEEK operation. Press
PREV or the SEEK down arrow to stop searching. The
sound is muted during PREV or SEEK operation.
._
__
.
I ? . , :
.
3-12
Advertisement
Table of Contents
