Table of Contents
Advertisement
6. Remove the Ton@
screws
at
the end
of
the
aiming ring. The aiming
ring will swing open like
a gate.
$ 1
10. Insert the tabs on
the aiming ring into
7. Remove. the aiming ring. Place it face down on the
8. Check that the number on the new headlamp
work surface with the aim indicator up.
matches the number on the headlamp being replaced.
The letter on
the
headlamp (U or L) must also match.
9. Put the new headlamp in position.
Makesure the socket points in the same direction
as it did with the old headlamp.
11. Holding the aiming ring closed, insert the screws at
the end of the ring. Tighten the screws until the
aiming ring touches the plastic nuts on both the top
and bottom.
0
Do not overtighten.
e
Do not damage the vertical aiming bubble.
Advertisement
Table of Contents
