Table of Contents
Advertisement
SUCCESS
I2C Error
FPGA_NO_INIT
FPGA_NO_DONE
EXT_SRAM ERROR
ECHO_BACK ERROR
FLASH_TIMEOUT
FLASH_ERROR
NO_FPGA_CODE
NO_COMMON_SETTINGS
NO_FACTORY_SETTINGS
OVER_TEMPERATURE
(Reserved)
NO_USER_FPN
NO_USER_PRNU
CLHS_TXRDY_RETRY
INVALID_UPGRADE
NO_USER_SETTINGS
NO_ADC_COEFFICIENTS
NO_SCRIPT
MAIN_BIST_NO_LINEARITY_COE
FFICIENTS
MAIN_BIST_GRRST_DISABLED
MAIN_BIST_NO_LUT
MAIN_BIST_NO_FACT_PRNU
Status LED
A single red/green LED is located on the back of the camera to indicate status.
LED State
Off
Constant Red
Blinking Red
Blinking Orange
Blinking Green
The Piranha XL XDR Camera
0x00000000
0x00000001
0x00000002
0x00000004
0x00000008
0x00000010
0x00000020
0x00000040
0x00000080
0x00000100
0x00000200
0x00000400
0x00000800
0x00001000
0x00002000
0x00004000
0x00008000
0x00010000
0x00020000
0x00040000
0x00080000
0x00100000
0x00200000
0x00400000
Description
Camera not power up or waiting for the software to start
The camera BIST status is not good. See BIST status for diagnosis.
The camera has shut down due to an over temperature condition.
Powering Up. The microprocessor is loading code.
Hardware is good, but the CLHS connection has not been established or has recently
No errors detected
Camera internal hardware
Camera internal hardware
Camera internal hardware
Camera internal hardware
Camera internal hardware
Camera internal hardware
Camera internal hardware
Camera internal hardware
Camera internal hardware
Camera internal hardware
The camera has detected excessive internal temperatures
and has partially shut down for protection. Remove power
to recover and improve airflow over the camera fins
-
The user has yet to save any FPN calibration data to a
User Set. (Note. Default values should have been set by
the factory)
The user has yet to save any PRNU calibration data to a
User Set. (Note. Default values should have been set by
the factory)
The camera cannot establish CLHS communications with
the frame grabber. Check the CLHS connection integrity.
An invalid file format or type was used when trying to
upgrade software or coefficients.
The User has yet to save a User Set (Note. Default values
should have been set by the factory)
Camera internal hardware
Camera internal hardware
Camera internal hardware
Camera internal hardware
Camera internal hardware
Camera internal hardware
• 63
Advertisement
Table of Contents
