6.3.1 Device status
The device status may display the following messages:
Message
Form
ERROR
red flashing
FWUPDATE
dark blue flashing
MEMORY
dark blue flashing
OK
dark blue
RING
dark blue flashing
WARNING
dark blue flashing
Table 6.5: Device status messages
More information on the device status in provided in the user guides of the data loggers, section
Memory space and level.
6.3.1.1
Memory full
If the memory of a connected logger is full, this will displayed as a flashing [MEMORY in the
Status / Overview
If the memory of a connected logger full, this will display a flashing [MEMORY] appears in the
Status / Overview display.
Figure 6.33: Memory full note in the Status / overview display
RCTouch_UserGuide_V3.4.1.doc
Remote Control Touch / blue PiraT Re-
mote
User Guide
Meaning
device in error mode
logger firmware is updated
lack of memory capacity
normal operation
logger in ring buffer mode
jeopardized operation
Datum:14.12.2018
Seite 50 von 82
Data recording
jeopardized
stopped
jeopardized
normal
normal
normal