Table of Contents
Advertisement
5.7
Wake up the Remote Control Touch over Kl 15
In order to start the Remote Control Touch in a TSL network with the other devices, it can be
waked up via KL 15.
We recommend the following configuration:
On a device which is woken up via a data bus, the Initial value is set to 1 on a digital
Output e.g. for DigitalOut #2. This means that it becomes active as soon as the logger
starts up.
Figure 5.13: Setting DigitalOut #2 to 1
The DIG OUT #2 socket of the logger is connected directly to the Kl 15 connector of
the Remote Control Touch and wakes it up.
Kl 15 on the Remote Control Touch is configured to [Wakeup on clamp 15].
Figure 5.5.14: Wakeup on clamp 15
As long as a participant of the TSL network receives data via a channel for which [Keep awake
on busload] is activated the TSL devices hold each other awake, therefore the option [Keep
awake on clamp 15] should be deactivated here!
5.7.1 Configuration before firmware version 03.02.01
The possibility of configuring clamp 15 was implemented in firmware version 03.02.01 first,
therefore a bypass solution is necessary for older firmware versions, since the connection is not
permanently kept awake with clamp 15.
To do this, DigitalOut #2 is set to 0 on the logger via a complex trigger as when the logger is
started.
New Trigger => [x] Trigger at message reception
Complex event => Expression: Al.1 > 10
RCTouch_UserGuide_V3.4.1.doc
Remote Control Touch / blue PiraT Re-
mote
User Guide
Datum:14.12.2018
Seite 26 von 82
Advertisement
Table of Contents
