Stratasys J850 Manual page 70

13. Click to display the next head alignment screen, and again select the
number representing the most closely aligned vertical lines on the
transparency for that print head.
When you have finished aligning all of the heads, the following screen is
displayed.
14. Continue as follows:
❒ To make the alignment changes in the printer, make sure that Update
system with new parameters is selected, and click
❒ To recheck the alignment test results before making the alignment
changes in the printer, click
❒ If you do not want to make alignment changes in the printer at this
time, select Keep previous parameters, and click
15. In the following screen, you can choose to either repeat the head
alignment procedure or close the wizard.
❒ If the most closely aligned vertical lines for a print head were at either
extreme, choose Repeat the test, then click
The transparency test will show if the heads are now properly aligned,
and—if not—the wizard will allow you to "fine tune" the alignment.
.
.
.
.