Stratasys J850 Manual page 109
3d printing systems
Hide thumbs
Also See for J850:
- User manual (132 pages) ,
- User manual (170 pages) ,
- User manual (181 pages)
Table of Contents
Advertisement
6. Loosen the screw securing the UV lamp cover (A), and pull the cover up
(B), then out (C).
7. Pull the UV lamp reflector out of the UV housing.
8. Inspect the new UV lamp reflector, and make sure that a black strip is
attached to the inside of it. If not, install one—on the side of the reflector
opposite (not next to) the print block.
9. Discard the old UV reflector and lamp.
Advertisement
Table of Contents
