Table of Contents
Advertisement
[Setup via recorder's main monitor]
About the removal process and the link process of hard disk
drives
When replacing hard disk drives, it is necessary to perform the removal process/ the link process.
Be sure to consult the dealer for the removal, installation, and the related process of hard disk drives.
Important:
• When the link process is performed, the data will be erased.
About the change of the HDD operational mode
About the HDD operational mode
Single mode:
Mirroring mode:
Change the operation mode of HDD [Change the operation mode of HDD]
Step 1
Click the [Execute >] button on the "Change the oper-
ation mode of HDD" section.
→ The "Change the operation mode of HDD" win-
→
dow will be displayed.
Step 2
Select the desired operation mode of HDD, and then
click the [Start] button.
Images and audio from the cameras will be recorded on the HDD of this product.
The same images and audio from the cameras will be recorded on the 2 HDDs of this
product.
When one of the 2 HDDs is replaced with a new one, it is possible to copy data on the
other HDD to the replaced HDD.
Step 2
Important:
• When the operational mode of HDD is changed
(except the case that the operational mode is
changed from the mirroring mode to the single
mode), all data on the HDDs will be erased.
• The capacity of the HDD in the mirroring mode will
become almost half if compared with the single
mode.
• When the operational mode of HDD is changed
from the mirroring mode to the single mode, the
status of the HDD will turn to "Playback-only".
• When "Operation mode of HDD" is changed, the
recorder will be automatically rebooted.
Note:
• When one of the HDDs is replaced in the mirroring
mode, "Add" will be displayed in the status infor-
mation section of "HDD information". The newly
replaced HDD will start working in the mirroring
mode when "Add HDD" is executed. In this case,
all data on the replaced HDD will be erased.
72
Advertisement
Table of Contents
