Table of Contents
Advertisement
[Setup via recorder's main monitor]
Set up VMD alarm [VMD alarm]
Select the VMD function for each camera and transmit the information to the cameras to change the camera
settings.
Clicking the [Setup >] button for "VMD alarm" on the [Camera setup] tab will display the setup page.
[VMD alarm]
Select whether or not to use the VMD (VMD: Video
Motion Detection) alarm function when a change
(movement) is detected in the image. Refer to the
operating instructions of the camera in use for how to
configure the VMD alarm.
On: Detects alarms.
Off: Does not detect alarms.
[Detection sensitivity]
To transmit the settings to the camera, mark this item,
and select either of the following.
1(Low) - 15(High)
■ Camera Selection
Select the camera to which the setting of the "VMD
alarm" is to be sent. Mark the checkbox of the camera
to which the setup information is to be transmitted.
[Transmission] button
Transmit the setting of the "VMD alarm" to the cam-
era.
Once transmission is completed and the setting has
been applied to the camera, "OK" will be displayed in
the "Results" field. If the display reads "Authentica-
tion error", etc., the camera connection or the setting
may have failed.
[Back] button
Click the button after completing the settings.
The screen returns to the [Camera setup] tab.
33
Advertisement
Table of Contents
