Table of Contents
Advertisement
[Setup via recorder's main monitor]
Set up Light control mode [Light control mode]
Select how to control the amount of light for each camera and transmit the information to the cameras to
change the camera settings.
Clicking the [Setup >] button for "Light control mode" on the [Camera setup] tab will display the setup page.
[Light control mode]
Outdoor scene: Depending on the brightness
level (illuminance), the iris will automatically be
controlled together with the shutter speed
adjustment to control light.
Indoor scene (50Hz): The shutter speed will auto-
matically be adjusted to prevent flicker caused
by fluorescent light. (For the 50 Hz areas)
Indoor scene (60Hz): Same as "Indoor scene"
above. (For 60 Hz areas)
■ Camera Selection
Select the camera to which the setting of the "Light
control mode" is to be sent.
Mark the checkbox of the camera to which the setup
information is to be transmitted.
[Transmission] button
Transmit the setting of the "Light control mode" to
the camera.
Once transmission is completed and the setting has
been applied to the camera, "OK" will be displayed in
the "Results" field.
If the display reads "Authentication error", etc., the
camera connection or the setting may have failed.
[Back] button
Click the button after completing the settings.
The screen returns to the [Camera setup] tab.
Note:
• When "Outdoor scene" is selected, flicker may
occur when a subject is under fluorescent lighting.
29
Advertisement
Table of Contents
