Camille Bauer PQ3K Operating Instructions Manual page 73

Power Quality
Type of device:
Measurement cycle: 200 ms (50Hz: 10 cycles; 60Hz: 12 cycles)
Flagging concept:
Certification:
Certification body:
Test records:
PQ functionality acc. IEC 61000-4-30 Ed.3
Chap. PQ parameter
5.1 Power frequency
5.2 Magnitude of the supply voltage
5.3 Flicker
5.4 Supply voltage dips and swells
5.5 Supply voltage interruptions
5.7 Supply voltage unbalance
5.8 Voltage harmonics
5.9 Voltage inter-harmonics
5.10 Mains signaling voltage
5.11 Rapid voltage change (RVC)
5.12 Underdeviation and overdeviation
5.13 Current (magnitude, harmonics, inter-harmonics, unbalance)
Zero suppression, range limitations
The measurement of specific quantities is related to a pre-condition which must be fulfilled, that the
corresponding value can be determined and sent via interface or displayed. If this condition is not fulfilled,
a default value is used for the measurement.
Quantity
Voltage
Current
PF
QF, LF, tanφ
Frequency
Voltage unbalance
Current unbalance
Phase angle U
Harmonics U, THD-U
1)
Specific levels depend on the device configuration
P10 Rev A
(IEC 62586-1) PQI-A FI2: Power Quality Instrument – Class A; Fixed installation;
Indoor environment with controlled temperature variations (2)
Multiphase approach in accordance with IEC 61000-4-30
According to IEC62586-2 (standard for verifying compliance with IEC 61000-4-30)
Federal Institute of Metrology METAS, an independent and accredited laboratory
Conformity was proven at 230V / 50Hz and 120V / 60Hz
Condition
Ux < 1% Ux
nom
Ix < 0,1% Ix
nom
Sx < 1% Sx
nom
Sx < 1% Sx
nom
voltage and/or current input too low
Ux < 5% Ux
nom
mean value of phase currents < 5% Ix
at least one voltage Ux < 5% Ux
fundamental < 5% Ux
Device handbook LINAX PQ3000-PQ5000
1)
nom
nom
nom
Class Remarks
A
A
A Flicker meter class F1
A
A
A
A
A
A
A
A
A
Default
0.00
0.00
1.00
0.00
Nominal frequency
0.00
0.00
120°
0.00
73/102