Camille Bauer PQ3K Operating Instructions Manual page 32

For a direct communication between device and PC both devices need to be in the same network when
the subnet mask is applied:
Example 1
IP address
Subnet mask
First address
Last address
The device 192.168.1.101 can access directly the devices 192.168.1.96 ... 192.168.1.127
►
Example 2
IP address
Subnet mask
First address
Last address
►
The device 192.168.57.64 can access directly the devices 192.168.56.0 ... 192.168.59.255
DHCP
If a DHCP server is available, alternatively the mode „DHCP" or „DHCP, addresses only" can be
selected for the Standard interface. The device then gets all necessary information from the DHCP server.
The difference between the two modes is that for "DHCP" also the DNS server address is obtained.
The settings obtained from the DHCP server can be retrieved locally via the service menu.
Depending on the settings of the DHCP server the provided IP address can change on each
reboot of the device. Thus, it's recommended to use the DHCP mode during commissioning
only.
P10 Rev A
decimal
192.168. 1.101
255.255.255.224
variable range
192.168. 1. 96
192.168. 1.127
decimal
192.168. 57. 64
255.255.252. 0
variable range
192.168. 56. 0
192.168. 59.255
Device handbook LINAX PQ3000-PQ5000
binary
11000000 10101000 00000001 01100101
11111111 11111111 11111111
11000000 10101000 00000001
11000000 10101000 00000001
binary
11000000 10101000 00111001 01000000
11111111 11111111
11000000 10101000
11000000 10101000
11100000
xxxxx
01100000
01111111
11111100 00000000
xx xxxxxxxx
00111000 00000000
00111011 11111111
32/102