Camille Bauer PQ3K Operating Instructions Manual page 38

Further steps during parameterization are:
 Assigning a unique device name via DCP protocol
 Assigning an IP address to the device, normally an automatic procedure
 Assembly of the cyclical process image (see below), maximum of 62 measurements
 Integration in the topology of the complete system
Because these steps are device independent and do rely on the used tool only, further details are not
given here.
Assembly of the cyclical process image
In Slot 1 always the module 'System state' is present providing the following information:
Bit Meaning
0 0: Measurement system stopped or not reachable
1: Measurement system running
0 ↔ 1: When the measurement system is running, the bit changes its state when the
1
value of at least one of the modules changes
2...31
not used, currently set to 0
Hints
 A parameterization of the base functionality of the device (such as the measurement functionality)
via PROFINET is not required
 A local modification of parameters (e.g. IP address, PROFINET device name) is not possible
P10 Rev A Device handbook LINAX PQ3000-PQ5000 38/102