Table of Contents
Advertisement
Install Other Devices
Install and connect any other devices in the system following the
steps below.
Floppy Disk Drive
The mainboard ships with a floppy disk drive cable that can
support one or two drives. Drives can be 3.5" or 5.25" wide, with
capacities of 360K, 720K, 1.2MB, 1.44MB, or 2.88MB.
Install your drives and connect power from the system power
supply. Use the cable provided to connect the drives to the floppy
disk drive header FDD1.
About UDMA
This board supports UltraDMA 33/66100. UDMA is a technology
that speeds the performance of devices in the IDE channel. We
recommend that you install IDE devices that support UDMA, and
use IDE cables that support UDMA.
IDE Devices
IDE devices include hard disk drives, high-density diskette drives,
and CD-ROM or DVD-ROM drives, among others.
The mainboard ships with an IDE cable that can support one or
two IDE devices. If you connect two devices to a single cable, you
must configure one of the drives as Master and one of the drives as
Slave. The documentation of the IDE device will tell you how to
2: Mainboard Installation
IDE1
IDE2
FDD1
1
1
1
17
Advertisement
Table of Contents
