Table of Contents
Advertisement
Mainboard User's Manual
DIMM2
DIMM1
DIMM3
For this mainboard, you must use 168-pin, 3.3V unbuffered
SDRAM/VCM SDRAM memory modules. If the installed CPU
uses a 100MHz system bus, you must use PC100 or PC133
memory. If the installed CPU uses a 133MHz system bus, you
must use PC133 memory. You can install any size memory module
from 16 MB to 512MB, so the maximum memory size is 3 x
512MB = 1.5GB.
The edge connectors on the memory modules have cut outs, which
coincide with spacers in the DIMM sockets so that memory
modules can only be installed in the correct orientation.
To install a module, push the retaining latches at either end of the
socket outwards. Position the memory module correctly and insert
it into the DIMM socket. Press the module down into the socket so
that the retaining latches rotate up and secure the module in place
by fitting into notches on the edge of the module.
Setting Jumper Switches
Jumpers are sets of pins which can be connected together with
jumper caps. The jumper caps change the way the mainboard
operates by changing the electronic circuits on the mainboard. If a
jumper cap connects two pins, we say the pins are SHORT. If a
jumper cap is removed from two pins, the pins are OPEN.
12
Advertisement
Table of Contents
